From: Roderick A. Anderson (raanders_at_tincan.org)
Date: Wed Feb 13 2002 - 09:20:48 EST
On Wed, 13 Feb 2002, Martin Josefsson wrote:
> Hi,
>
> I noticed that it's possible to see all ipaddresses on all interfaces in
> an vserver when it should only be possible to see the ipv4root address.
Seems to me the lastest kernel and package make this so.
Here is the results of ifconfig in a virtaul server
eth0 Link encap:Ethernet HWaddr 00:80:AD:71:22:2C
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:701060 errors:0 dropped:0 overruns:0 frame:0
TX packets:48393 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:76531350 (72.9 Mb) TX bytes:7184647 (6.8 Mb)
Interrupt:11 Base address:0xe800
eth0:vs1 Link encap:Ethernet HWaddr 00:80:AD:71:22:2C
inet addr:216.64.180.227 Bcast:216.64.180.255 Mask:255.255.255.255
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
Interrupt:11 Base address:0xe800
lo Link encap:Local Loopback
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:877 errors:0 dropped:0 overruns:0 frame:0
TX packets:877 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:75810 (74.0 Kb) TX bytes:75810 (74.0 Kb)
> ifconfig works as it should but ip from the iproute2 package uses netlink
> IIRC and there I can see all addresses of all interfaces.
OOPS! Is the above relavant?
Regards,
Rod
--
Let Accuracy Triumph Over Victory
Zetetic Institute
"David's Sling"
Marc Stiegler
This archive was generated by hypermail 2.1.4 : Mon Aug 19 2002 - 12:01:01 EDT